Special:
|
[DAT] (requires LDraw-compatible viewer)
|
Subject:
|
Re: x342: ~Technic Flex-System End
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 31 Jul 2002 21:35:45 GMT
|
Viewed:
|
1484 times
|
| |
|
|
"Ross Crawford" <rcrawford@csi.com> writes:
> OK. Updated BFC certified versions now available at
> http://www.ozbricks.com/bre/etc/flex1.zip
Nice ones. I've updated LDraw-mode to handle these unofficial parts.
No documentation has been added yet, but it works the usual way. Here's
an example. Try these two end parts:
0
1 8 50 0 0 0 0 -1 1 0 0 0 -1 0 x342.DAT
1 8 0 0 50 0 -1 0 -1 0 0 0 0 -1 x342.DAT
0
Put the cursor on either of the part lines, and press C-c C-b. You will
be prompted for the length of the cable to insert, try 46, or perhaps
45.5. Emacs will chew a few CPU cycles while the program numerically
optimizes the curvature, then the appropriate segments are inserted.
All comments are appreciated, obviously!
Here's the new source:
http://folk.uio.no/fredrigl/technic/ldraw-mode/ldraw-mode.el
General info at:
http://folk.uio.no/fredrigl/technic/ldraw-mode/
Fredrik
|
|
Message is in Reply To:
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
