 | | Question about stud orientation —Travis Cobbs
|
| | | I noticed when looking at part 6002 posted at the tracker that one of the studs is rotated 90 degrees when compared to the other three. This is only visible if you use a program that supports stud logos (such as my LDView program). Is this something (...) (22 years ago, 16-Jun-02, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: Question about stud orientation —Lars C. Hassing
|
| | | | Travis Cobbs wrote... (...) BTW, L3P has a problem with mirrored parts: Part 3935.DAT "0 Wing 4 x 4 Right" only has one line: 1 16 0 0 0 -1 0 0 0 1 0 0 0 1 3936.dat which is a mirror of the left wing. If L3P were to render the stud logos correctly, (...) (22 years ago, 18-Jun-02, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Question about stud orientation —Tore Eriksson
|
| | | | (...) Hmm, isn't there any abs[-olute value] function that one could insert somewhere so that the x and z values for the studs are either both positive or both negative? /Tore (22 years ago, 19-Jun-02, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Question about stud orientation —Lars C. Hassing
|
| | | | Tore Eriksson wrote... (...) The main problem is, that the POV code of an object is only parsed and evaluated once, and not each time an object is referenced/instantiated. Any conditions/expressions are evaluated once and compiled into a binary (...) (22 years ago, 19-Jun-02, to lugnet.cad.dat.parts)
|
| | | | |
