Subject:
|
Re: Question about stud orientation
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 19 Jun 2002 20:16:59 GMT
|
Viewed:
|
1513 times
|
| |
|
|
In lugnet.cad.dat.parts, Lars C. Hassing writes:
>
> BTW, L3P has a problem with mirrored parts:
> Part 3935.DAT "0 Wing 4 x 4 Right" only has one line:
> 1 16 0 0 0 -1 0 0 0 1 0 0 0 1 3936.dat
> which is a mirror of the left wing.
Hmm, isn't there any abs[-olute value] function that one could insert
somewhere so that the x and z values for the studs are either both positive
or both negative?
/Tore
|
|
Message has 1 Reply:
 | | Re: Question about stud orientation
|
| Tore Eriksson wrote... (...) The main problem is, that the POV code of an object is only parsed and evaluated once, and not each time an object is referenced/instantiated. Any conditions/expressions are evaluated once and compiled into a binary (...) (22 years ago, 19-Jun-02, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Question about stud orientation [DAT]
|
| Travis Cobbs wrote... (...) BTW, L3P has a problem with mirrored parts: Part 3935.DAT "0 Wing 4 x 4 Right" only has one line: 1 16 0 0 0 -1 0 0 0 1 0 0 0 1 3936.dat which is a mirror of the left wing. If L3P were to render the stud logos correctly, (...) (22 years ago, 18-Jun-02, to lugnet.cad.dat.parts)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
