Subject:
|
Re: Minifig Torso Johnny Thunder (needs part number)
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 10 Jun 2002 17:54:36 GMT
|
Viewed:
|
1908 times
|
| |
|
|
In lugnet.cad.dat.parts, George Barnes writes:
> I'm not sure what you are referring to. Is the gap an actual hole in the
> front panel? or is it the collar and neck are about a unit from the top of
> the shirt (it was like this on the actual minifig)? placement of the neck mark?
>
> I noticed that ldview seems to have a problem displaying torsos. It seems
> to leave gaps between the subpart and the added pieces (front panel, back
> panel, neck mark). This goes away if you set the seem width down to zero.
>
> Let me know. I want to fix this and I highly value your opinion.
>
> George
>
>
> In lugnet.cad.dat.parts, Franklin W. Cain writes:
> > > Here is the updated part with the neck mark, back,
> > > and the hole above the pocket fixed.
> >
> > It still has the gap in the pattern's "neck" (i.e., Johnny's open shirt
> > collar).
> >
> > Franklin
George,
It sounds like you are experiencing the same problem I was. You have a qaud
that has colinear points. For some reason L3Lab, the program Franklin uses,
doesn't like quads with colinear vertices and doesn't display them. This
problem doesn't show up in MLCad or LDView. I fixed this problem by
splitting the quad into 2 triangles. If you help with this, let me know.
-Orion
(make it billthefish and remove the obvious lettering to reply personally)
|
|
Message has 1 Reply:
Message is in Reply To:
14 Messages in This Thread:
   
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
