 | | My first part - Fabuland Car Door, PLMKWYT —Carl Watson
|
| | | Fabuland Car Door. Any thoughts or suggestions would be greatly appreciated. Also - should the round bit on the end of the door be created with a disc or triangles/quads? I can't seem to find the part number - now what. 0 Fabuland Car Door 0 part (...) (23 years ago, 13-Dec-01, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: My first part - Fabuland Car Door, PLMKWYT —Steve Bliss
|
| | | | | (...) OK. Can do. Will do. Well, as much as I can. (...) I'm not familiar with this piece; general advice is if the radius of the curve is 1LDU or less, don't bother with modelling it as curved. (...) If there's no number on it, then I can supply a (...) (23 years ago, 14-Dec-01, to lugnet.cad.dat.parts)
|
| | | | | |
| | | | | Re: My first part - Fabuland Car Door, PLMKWYT —Chris Dee
|
| | | | (...) A great start for a first part. (...) I suggest you add "Right". (...) I have a few (hopefully constructive) comments. The orientation and origin should be consistent with other car doors (eg 3821.dat). The raised section at the end of the (...) (23 years ago, 14-Dec-01, to lugnet.cad.dat.parts)
|
| | | | |
