 | | Re: Subpart thingy. —Mark Kennedy
|
| | | (...) What program are you using to view the part? I looked at it in l3lab and it looked fine. There is not supposed to be a top surface on the part. (24 years ago, 25-Oct-01, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: Subpart thingy. —Lars C. Hassing
|
| | | | (...) Great program, huh? I use it too :-) If you look at it from the bottom you can see that the T-surface is divided into two by an edge-line (Zoom 3000%): (URL) always hidden surface is seen here: (URL) the subpart is made out of quads (and not (...) (24 years ago, 25-Oct-01, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Subpart thingy. —Mark Kennedy
|
| | | | (...) Sorry, my browser can't veiw .png files. (24 years ago, 26-Oct-01, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Subpart thingy. —Lars C. Hassing
|
| | | | If you look at it from the bottom you can see that the T-surface is divided into two by an edge-line (Zoom 3000%): (URL) always hidden surface is seen here: (URL) the subpart is made out of quads (and not boxes) you can split the long surface into (...) (24 years ago, 26-Oct-01, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Subpart thingy. —Mark Kennedy
|
| | | | (...) The extra line IS present in the 30504 piece, at least the one that I had, as well as several other peices. It is just very faint. As for the hidden surface, I wouldn't worry too much about it unless it were to crash your system or slow down (...) (23 years ago, 27-Oct-01, to lugnet.cad.dat.parts)
|
| | | | |
