Subject:
|
Re: Part 30562 Wall 1 x 4 x 6 Corner Round (with bottom added)
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 11 Sep 2001 12:28:28 GMT
|
Viewed:
|
4092 times
|
| |
|
|
Ah - I'll take a look at your mods before I make any myself. :)
In lugnet.cad.dat.parts, Don Heyse writes:
> In lugnet.cad.dat.parts, Mark Kennedy writes:
> > In lugnet.cad.dat.parts, Mark Chittenden writes:
> > > 99% finished, but I was hitting burn-out factor on this one. The
> > > bottom needs work, for now has bottom studs in place of the boxed off
> > > sections. Now, since NO WAY am I up to putting images on a curved
> > > surface, it's up to someone else to 'paint' or 'skin' this with the
> > > escape pod panel design from the kit Droid Escape.
> >
> > I would suggest using bits from part 30056 for the bottom half. That's
> > what I did when I worked on the quarter panel with spherous top. Also
> > I would use 1-4CYLI.DAT, 1-4EDGE.DAT, and and 1-4RING3 primitives in
> > the file to reduce size.
>
> Cool, another excuse to put the 3 months I spent on the bottom half of
> 30056 to some use. I don't know how you guys can zip out these parts
> so fast. It took me forever to do that one piece, and I asked Steve so
> many questions he might as well have done it himself.
>
> Anyhow, I added the bottom bits and replaced a few sections with
> primitives and here it is. If anyone wants to 'skin' it you just have
> to replace the first big cylinder with a painted one. I don't have
> the skill to do that either...
>
> Don
>
|
|
Message is in Reply To:
5 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
