Subject:
|
Re: Part 30562 Wall 1 x 4 x 6 Corner Round
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Tue, 11 Sep 2001 12:27:20 GMT
|
Viewed:
|
1507 times
|
| |
|
|
Thanks! Didn't even knew that part existed. Thought all previous fences & walls
were flat or diangle, not curved. :)
In lugnet.cad.dat.parts, Mark Kennedy writes:
> In lugnet.cad.dat.parts, Mark Chittenden writes:
> > 99% finished, but I was hitting burn-out factor on this one. The bottom needs
> > work, for now has bottom studs in place of the boxed off sections. Now, • since
> > NO WAY am I up to putting images on a curved surface, it's up to someone else
> > to 'paint' or 'skin' this with the escape pod panel design from the kit Droid
> > Escape.
> >
> > http://www.brickshelf.com/cgi-bin/gallery.cgi?i=68807
> >
> >
> I would suggest using bits from part 30056 for the bottom half. That's what I
> did when I worked on the quarter panel with spherous top. Also I would use
> 1-4CYLI.DAT, 1-4EDGE.DAT, and and 1-4RING3 primitives in the file to reduce
> size.
|
|
Message is in Reply To:
 | | Re: Part 30562 Wall 1 x 4 x 6 Corner Round
|
| (...) I would suggest using bits from part 30056 for the bottom half. That's what I did when I worked on the quarter panel with spherous top. Also I would use 1-4CYLI.DAT, 1-4EDGE.DAT, and and 1-4RING3 primitives in the file to reduce size. (23 years ago, 10-Sep-01, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
