Subject:
|
Re: Part 30562 Wall 1 x 4 x 6 Corner Round
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Mon, 10 Sep 2001 08:41:10 GMT
|
Viewed:
|
1406 times
|
| |
|
|
In lugnet.cad.dat.parts, Mark Chittenden writes:
> 99% finished, but I was hitting burn-out factor on this one. The bottom needs
> work, for now has bottom studs in place of the boxed off sections. Now, since
> NO WAY am I up to putting images on a curved surface, it's up to someone else
> to 'paint' or 'skin' this with the escape pod panel design from the kit Droid
> Escape.
>
> http://www.brickshelf.com/cgi-bin/gallery.cgi?i=68807
>
>
I would suggest using bits from part 30056 for the bottom half. That's what I
did when I worked on the quarter panel with spherous top. Also I would use
1-4CYLI.DAT, 1-4EDGE.DAT, and and 1-4RING3 primitives in the file to reduce
size.
|
|
Message has 2 Replies:
Message is in Reply To:
 | | Part 30562 Wall 1 x 4 x 6 Corner Round [DAT]
|
| 99% finished, but I was hitting burn-out factor on this one. The bottom needs work, for now has bottom studs in place of the boxed off sections. Now, since NO WAY am I up to putting images on a curved surface, it's up to someone else to 'paint' or (...) (23 years ago, 10-Sep-01, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
