 | | Re: Unofficial part: 2852 Technic Connecting Rod
|
|
Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3g14udcwh.fsf@....uio.no... (...) The 1/4 cylinder wedge thingy connecting the lower stud with the arm doesn't join the stud quite right. It should extend further down around the (...) (26 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2852 Technic Connecting Rod
|
|
(...) Thanks! I'll check it out when I get home. (...) Do you mean where the wedge thing meets the rectangular rod, on both sides? Those edges were left out intentionally, because I have really modeled a curved surface with two plane ones. There (...) (26 years ago, 19-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2852 Technic Connecting Rod
|
|
Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3ogjh8f3z.fsf@....uio.no... (...) The edge I'm talking about is parallel to the "left-out" edge to which you point, to the right and down a little. It should start where the top (...) (26 years ago, 19-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Unofficial part: 2852 Technic Connecting Rod
|
|
(...) Ah, yes. I saw it at once when I got home and pushed "wireframe mode". Thanks for the hint. (...) Yes, I should probably do that. I'll let the project rest for a couple of days right now, and see if I can get back to it later. This part is (...) (26 years ago, 20-May-99, to lugnet.cad.dat.parts)
|
