Subject:
|
Re: Unofficial part: 2852 Technic Connecting Rod
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 19 May 1999 11:37:36 GMT
|
Viewed:
|
1033 times
|
| |
|
|
"John VanZwieten" <john_vanzwieten@email.msn.com> writes:
> The 1/4 cylinder wedge thingy connecting the lower stud with the arm
> doesn't join the stud quite right. It should extend further down
> around the stud.
Thanks! I'll check it out when I get home.
> There are a couple edge lines missing on the side of the arm. Take a
> look in wireframe from an oblique angle and this will be obvious.
Do you mean where the wedge thing meets the rectangular rod, on both
sides? Those edges were left out intentionally, because I have really
modeled a curved surface with two plane ones. There isn't supposed to
be an edge in the real part at this place; there is simply a gradually
curving surface. This is much like on the "front" of the part, where
the stud meets the rectangular rod. At the front, I used a 1-4cyli.dat
to model the curved surface, and I left out the edge where the
1-4cyli.dat meets the rod.
Here's an illustration:
http://www.math.uio.no/~fredrigl/technic/ldraw/2852-ill.gif
The white arrow points at where I've intentionally left out an edge.
I think the edges should be left out at the sides of the rod. What do
you guys think?
Please ask more questions if I'm being unclear.
Fredrik
|
|
Message has 1 Reply:
 | | Re: Unofficial part: 2852 Technic Connecting Rod
|
| Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3ogjh8f3z.fsf@....uio.no... (...) The edge I'm talking about is parallel to the "left-out" edge to which you point, to the right and down a little. It should start where the top (...) (26 years ago, 19-May-99, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Unofficial part: 2852 Technic Connecting Rod
|
| Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3g14udcwh.fsf@....uio.no... (...) The 1/4 cylinder wedge thingy connecting the lower stud with the arm doesn't join the stud quite right. It should extend further down around the (...) (26 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
