 | | Unofficial part: 2852 Technic Connecting Rod —Fredrik Glöckner
|
| | | 0 Technic Connecting Rod 0 Name: 2852.dat 0 Author: Fredrik Glöckner 0 Un-Official Element 2 24 -3.04 -33.96 4 -4 -34.63 4 2 24 0 -33.25 4 -3.04 -33.96 4 2 24 0 -33.25 4 3.04 -33.96 4 2 24 3.04 -33.96 4 4 -34.63 4 2 24 4 -33.96 3.04 4 -34.63 4 2 24 (...) (25 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: Unofficial part: 2852 Technic Connecting Rod —John VanZwieten
|
| | | | Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3g14udcwh.fsf@....uio.no... (...) The 1/4 cylinder wedge thingy connecting the lower stud with the arm doesn't join the stud quite right. It should extend further down around the (...) (25 years ago, 18-May-99, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Unofficial part: 2852 Technic Connecting Rod —Fredrik Glöckner
|
| | | | (...) Thanks! I'll check it out when I get home. (...) Do you mean where the wedge thing meets the rectangular rod, on both sides? Those edges were left out intentionally, because I have really modeled a curved surface with two plane ones. There (...) (25 years ago, 19-May-99, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Unofficial part: 2852 Technic Connecting Rod —John VanZwieten
|
| | | | Fredrik Glöckner <fredrik.glockner@bio.uio.no> wrote in message news:m3ogjh8f3z.fsf@....uio.no... (...) The edge I'm talking about is parallel to the "left-out" edge to which you point, to the right and down a little. It should start where the top (...) (25 years ago, 19-May-99, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: Unofficial part: 2852 Technic Connecting Rod —Fredrik Glöckner
|
| | | | (...) Ah, yes. I saw it at once when I got home and pushed "wireframe mode". Thanks for the hint. (...) Yes, I should probably do that. I'll let the project rest for a couple of days right now, and see if I can get back to it later. This part is (...) (25 years ago, 20-May-99, to lugnet.cad.dat.parts)
|
| | | | |
