Subject:
|
Re: New Part - 2527 Plate? 2 x 4 cannon base
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 13 Dec 2000 17:54:44 GMT
|
Viewed:
|
786 times
|
| |
|
|
In lugnet.cad.dat.parts, Paul Easter wrote:
> I finished(?) this part a few weeks ago and didn't see where I posted it.
> It is the 2 x 4 cannon base.
> I need some suggestions on category & keywords...
Very nice job on these parts!
I think I'd name the cannon parts as:
2527.DAT Minifig Cannon 2 x 4 Base
x518.DAT Minifig Cannon 2 x n Non-Shooting
Sorry, I don't have a cannon handy for measurement -- replace the 'n' with
the proper length.
Categorize both parts as "Minifig Accessory". They are somewhat large for
this category, but I can't think of where else they'd go.
Steve
|
|
Message has 1 Reply:
 | | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
| (...) Is it necessary to specify a length 'n' if it's an accessory? That is, does the Minifig Tool Knife (whatever it's called specifically) mention a length? I'm just curious, but it seems that unless there's a length difference between shooting (...) (24 years ago, 13-Dec-00, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | New Part - 2527 Plate? 2 x 4 cannon base [DAT]
|
| Hi again!!! I finished(?) this part a few weeks ago and didn't see where I posted it. It is the 2 x 4 cannon base. I need some suggestions on category & keywords... Let me know if I need to change anything. Picture available here; (URL) you, Paul (...) (24 years ago, 13-Dec-00, to lugnet.cad.dat.parts)
|
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
