Subject:
|
Re: New Part - 2527 Plate? 2 x 4 cannon base
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Wed, 13 Dec 2000 18:31:30 GMT
|
Viewed:
|
847 times
|
| |
|
|
> > x518.DAT Minifig Cannon 2 x n Non-Shooting
>
> Is it necessary to specify a length 'n' if it's an accessory?
Nope. Just call it "Minifig Cannon Non-Shooting"
if you want.
I've added *lots* of minifig weapons-of-individual-destruction
to the inventory, and I didn't state the length of any of them...
(Well, I *did* specify that the greatsword was indeed a *greatsword" --
minifig-scale -- instead of any regular ol' pig-sticker, but that's
besides the point. ;-)
The Cannon *BASE*, on the other hand, should indeed be measured,
as it is, from the underside, a 2x4 plate/brick/[other piece].
Franklin
|
|
Message is in Reply To:
 | | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
| (...) Is it necessary to specify a length 'n' if it's an accessory? That is, does the Minifig Tool Knife (whatever it's called specifically) mention a length? I'm just curious, but it seems that unless there's a length difference between shooting (...) (24 years ago, 13-Dec-00, to lugnet.cad.dat.parts)
|
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
