 | | Un-Official Part: Technic Connector with Axle Hole [DAT]
|
|
0 Technic Connector with Axle Hole 0 Author: Fredrik Glöckner 0 Un-Official Element 0 Using the Emacs + LDraw-mode + LDLITE combo, modeling parts is a 0 breeze! 0 As always, please notify me if there are any mistakes here. And can I 0 have a number (...) (26 years ago, 16-May-99, to lugnet.cad.dat.parts)
|
| |
| | Re: Un-Official Part: Technic Connector with Axle Hole
|
|
good. does this mean that you will now be finishing your engine parts??? (26 years ago, 16-May-99, to lugnet.cad.dev)
|
| |
| | Re: Un-Official Part: Technic Connector with Axle Hole
|
|
(...) I probably should, yes. As for the 2853 Technic Crankshaft, my draft at (URL) obvoiusly misplaced -- It's not centered. So when I make a proper one, I need to update all my models: Bah. Anyway, how should the part be placed and rotated? I (...) (26 years ago, 17-May-99, to lugnet.cad.dev)
|
| |
| | Re: Un-Official Part: Technic Connector with Axle Hole [DAT]
|
|
(...) Well, as this piece is commonly used with the 2854, and that piece is already in the vote in its own position, I would place the 2853 in the default position easiest to use with the 2854. That would require a 180 degree flip of the 2853 and a (...) (26 years ago, 17-May-99, to lugnet.cad.dev)
|
| |
| | Re: Un-Official Part: Technic Connector with Axle Hole
|
|
(...) I originally thought that the 2853, the axle #2 with offset crank, should have the axle oriented in the X-direction, as do all axles in LDraw, and that the 2854 should have the axle hole oriented in the X-direction, as do almost all parts in (...) (26 years ago, 17-May-99, to lugnet.cad.dev)
|
