 | | Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern —Larry Pieniazek
|
| | | (...) When viewed in MLCad: The first posted version of this part had some bleedthrough of the underside tubes and pins... but the version referenced does not.... is that due to the line length correction? I like this part a lot, it will be very (...) (24 years ago, 26-May-00, to lugnet.cad.dat.parts)
|
| | | |
| | | | | Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern —Imre Papp
|
| | | | Larry Pieniazek <lar@voyager.net> wrote in message news:Fv5s5q.6ut@lugnet.com... (...) Thanks Larry, I'm happy that you like it. No. The linelength correction refers only to a change Outlook to avoid line wrapping, there were no other changes in (...) (24 years ago, 28-May-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern —Larry Pieniazek
|
| | | | (...) Can someone else try looking at both the first and second versions of hte part and see if they see bleedthrough? It might have been me. I was viewing it with MLCad 1.7 ++Lar (24 years ago, 29-May-00, to lugnet.cad.dat.parts)
|
| | | | |
| | | | | | Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern —Steve Bliss
|
| | | | | (...) Using MLCad 1.7, I get some bleed-through and noise (could be the same things) in both versions. In L3Lab, everything looks good. Steve (24 years ago, 30-May-00, to lugnet.cad.dat.parts)
|
| | | | | |
| | | | | | Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern —Imre Papp
|
| | | | Really, I was able to detect the bleedthrough on the underside. With L3Lab I heavily rotated the part in all possible directions stopping time to time at the underside. Sometimes I could see some random blobs. So I disassembled the part (removed my (...) (24 years ago, 30-May-00, to lugnet.cad.dat.parts)
|
| | | | |
