Subject:
|
Re: [Part] 4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Patt ern
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Fri, 26 May 2000 08:41:50 GMT
|
Viewed:
|
2918 times
|
| |
|
|
In lugnet.cad.dat.parts, Imre Papp writes:
> Sorry, the linelength should be OK now.
>
> Papp Imre <ipapp@GEOMETRIA.hu> wrote in message news:D148AB3A9D8FD311A99A008048C79D1119B3D1@MAIL...
> > Dear part authors,
> >
> > I attach the '4515p03.dat - Slope Brick 10 6 x 8 with Slate Roof Pattern'
> > part for review and comments.
> >
> > Questions and requests for comment:
> >
> > 1. Is the part numbering correct. The base part number is obvious, for the
> > p03 suffix I chose the next free pattern number. Does not conflict with
> > other patterned parts?
> >
> > 2. Is the pattern naming acceptable (Slate Roof) ?
> >
> > 3. My technique was to remove the top rectangle and substitute entirely with
> > the roof pattern. I took care to adjust the borders of the patterned
> > poligons to edges of remaining part. Numerically they fit correctly, however
> > when viewing in L3Lab or Ldlite with high magification I notice some
> > incorrectness at the edges of the roof pattern. Can anybody else see it? If
> > yes what to do?
> >
> > Thanks
When viewed in MLCad:
The first posted version of this part had some bleedthrough of the
underside tubes and pins... but the version referenced does not.... is that
due to the line length correction?
I like this part a lot, it will be very handy, if it gets approved.
++Lar
|
|
Message has 1 Reply:
Message is in Reply To:
7 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
