 | | Re: 2867.dat Curved 9V Track - reddy
|
|
(...) Very nice! Good work on this. :) However (I always seem to have a 'however' ;), I'm not sure about your choice of the zero-point and the orientation of the part. The point you chose was very logical, but it might not be practical. In relation (...) (21 years ago, 19-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 9V Curved Track
|
|
(...) The information i have abouth parts center comes from the LDRAW FAQ - Question24 Steve Bliss writes : Quote Tip#1: The Ldraw standard for positioning is to the center of the piece on X=0 and Z=0. Usually, the top of the part (excluding studs) (...) (21 years ago, 17-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 2867.dat Curved 9V Track - ready
|
|
(...) <SNIP> (...) Perhaps not for you, but without this little piece of software wouldn't i be able to create this part. It was just THIS that make me believe that i could create this part. I'm not a mathematic gouru, and trust me, i'm going to (...) (21 years ago, 17-Apr-03, to lugnet.cad.dat.parts)
|
| |
| | Re: 9V Curved Track
|
|
(...) ... (...) It's the 'normal' part that trips me up! Consider these parts: (URL) a geometry point of view, these are pretty similar. But (according to MLCad) the center of the macaroni is the circle center; the center of the 2x2 'L' is the (...) (21 years ago, 17-Apr-03, to lugnet.trains, lugnet.cad.dat.parts)
|
| |
| | Re: 2867.dat Curved 9V Track - ready
|
|
Great! Many thanks for the enormous work you have laid down in this part. /Tore Eriksson (without 'c') (...) Ah, nothing to mention. :o) (...) (21 years ago, 17-Apr-03, to lugnet.cad.dat.parts)
|
