 | | How to get UNOFFICIAL parts files to show up on LDRAW/MLCAD
|
|
OK, I downloaded the unofficial parts files from ldraw.org and placed them in my "models" directory (so I don't contaminate my "official" parts directory), but how do I get MLCAD to switch to look at them? Nothing is shown under my "models" tree in (...) (22 years ago, 17-May-02, to lugnet.cad.dat.parts)
|
| |
| | Re: "Hold" placed on tyre (was Re: Tyre for this wheel, does it exist in the distro?
|
|
"TWS Garrison" <tgarrisBASSo@ISmath...urdue.edu> skrev i meddelandet news:Pine.GSO.4.44.0...due.edu... (...) I think this is a very important point! As soon as a part has the right orientation, zero point and outer dimensions, it can be _used_ for (...) (22 years ago, 14-May-02, to lugnet.cad.dat.parts, lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Creating Patterned Parts
|
|
(...) I prefer either 32 (Trans-Black) or 40 (Trans-Dk.Grey)... Franklin (22 years ago, 15-May-02, to lugnet.cad.dev, lugnet.cad.dat.parts)
|
| |
| | Re: new "Star Wars" files...
|
|
"Franklin W. Cain" <fwcain@yahoo.com> wrote in message news:Gw4CoC.Jp0@lugnet.com... (...) No problem. I'll take a look tomorrow. (...) Good luck. Dan (22 years ago, 14-May-02, to lugnet.cad.dat.parts)
|
| |
| | Creating Patterned Parts
|
|
Now that my first part has been certified I'm going to continue on my quest to get all the part for the UCS Tie Fighter created. I've been working on the patterned windscreen (part 2598) for some time now but can't get the angles for some of the (...) (22 years ago, 14-May-02, to lugnet.cad.dev, lugnet.cad.dat.parts)
|
