| | Re: New Part - x518 Cannon Pirate
|
|
(...) I will use "Minifig Accessory" as Steve recommended. (...) ok. (...) The cannons I have are the one piece design with the crossed cannon symbol on them. I can do the logo, but it will not look very good rendered. I tried to use as many POV (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
|
| | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
|
(...) If it doesn't matter much to anyone, I will rename these parts as Steve stated a few messages back; 2527.DAT Minifig Cannon 2 x 4 Base x518.DAT Minifig Cannon 2 x 8 Non-Shooting ( I measured it, end to end) I will categorize both parts as (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
|
| | Re: New Part - 2527 Plate? 2 x 4 cannon base
|
|
(...) Hi Franklin, When you say to re-orient this part, do I need to point the open end of the barrel to the z+ or z- ? (for clarification) Also, I believe you said to also re-orient the base as well. I will turn it to match the cannon. Let me know (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
|
| | Re: New Part - 30187 Minifig Motorcycle with 3 Wheels Body
|
|
(...) Thanks! They were a challenge. Especially to get all the parts to fit together. When I dis-assembled the base and the body, the base distorted slightly, and I had to find another assembled bike. (...) ok. (...) It was the only one that made (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|
|
| | Re: New Part - 30189 Minifig Motorcycle with 3 Wheels Handlebars
|
|
(...) Hi Bram, Thank you for the comments. I try to use primitives am much as possible to make the best looking POV rendered parts. Paul (...) (24 years ago, 15-Dec-00, to lugnet.cad.dat.parts)
|