 | | Wrong parts listed on Peeron for Model #6390-1 Main Street?
|
|
The peeron parts lists specifies that there are: 7 3855 Clear Glass for Window 1 x 4 x 3 (Ref) Looking at the model manual (I do not have the original model), it appears to me that there are two distinct window glasses here, neither of which match (...) (22 years ago, 5-Feb-03, to lugnet.cad.dat.models)
|
| |
| | Re: Wrong parts listed on Peeron for Model #6390-1 Main Street?
|
|
(...) Anyone with the actual set is welcome to confirm/deny my statements here. I have the Paramedic Unit set #6364 which is from the same year (or just before/after the Main Street set.) It uses 3 of the windows #3855, which Peeron lists correctly. (...) (22 years ago, 6-Feb-03, to lugnet.cad.dat.models)
|
| |
| | Re: Wrong parts listed on Peeron for Model #6390-1 Main Street?
|
|
I guess the bump on the glass just wasn't showing up in my mlcad views. Once rendered, however, they were there. With regards to the sticker on the windows, do you happen to have a count of the exact # of lines (or even better, a pointer to a scan (...) (22 years ago, 6-Feb-03, to lugnet.cad.dat.models)
|
| |
| | Re: Wrong parts listed on Peeron for Model #6390-1 Main Street?
|
|
(...) Try this link to see a (poor) scan of the blinds sticker on the glass. (URL) sticker was applied to the side opposite the hole..... which, looking again at it, is the backside of the scan. Hmmmmmmm. If this causes any problems just let me (...) (22 years ago, 6-Feb-03, to lugnet.cad.dat.models)
|
| |
| | Re: Wrong parts listed on Peeron for Model #6390-1 Main Street?
|
|
Ok, it turns out I wasn't imagining things. 3855.DAT, Glass window 1 x 4 x 3 is either modelled incorrectly or the part being used for the glass pains in the 6390 Main Street kit is listed incorrectly at peeron.com. If it's the same part being used (...) (22 years ago, 7-Feb-03, to lugnet.cad.dat.models)
|
| |
| | Re: Wrong parts listed on Peeron for Model #6390-1 Main Street?
|
|
In lugnet.cad.dat.models, Karl Asha writes: <snip> (...) The corect way is to model the sticker separately and call it a sticker. The rule for modelling stickers are summed up in this thread: (URL) at the bottom and the follow on replies -Orion (22 years ago, 8-Feb-03, to lugnet.cad.dat.models)
|
