 | | Re: 16L sailmast *30219.dat*
|
|
It looks ok. I added these two lines in my local copy of the file: 0 Unofficial Part 0 BFC NOCERTIFY /Tore (22 years ago, 1-Jun-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Question about creating Cone 4 x 4 x 3 for LDraw
|
|
(...) Are you saying that the LEGO on the stud is rotated 45 degrees from how you would expect it to be aligned? Or are you saying something else. if the former, I agree with Don, I'd have the default orientation the one that people are most likely (...) (22 years ago, 1-Jun-04, to lugnet.cad.dat.parts)
|
| |
| | 16L sailmast *30219.dat* [DAT]
|
|
seen in arctic set 6579 original code modified from franklin cain's part 0 Bar 16L with Hollow Studs, Towball, and Slit 0 Name: 30219.dat 0 Original Author: Franklin W. Cain 0 Author: Thomas Burger 0 KEYWORDS Arctic, Xtreme Team, Xtreme Stunts, (...) (22 years ago, 31-May-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Question about creating Cone 4 x 4 x 3 for LDraw
|
|
(...) I don't really want a part rotated 45 degrees from direction it's going to be placed. The Ldraw 'A' command works in 90 degree angles. That's why I chose the orientation I did for the mockup. Plus it matches the other cones. I'd say leave the (...) (22 years ago, 31-May-04, to lugnet.cad.dat.parts)
|
| |
| | Re: Onion Dome (part 44511) from Orient Expedition sets
|
|
In lugnet.cad.dat.parts, William Howard wrote: (snip) I wanted to close the loop on this.. William is right, and I was incorrect about the cross section. I agree that there is no recurve in the part, and thus no figure 8 cross sections when put back (...) (22 years ago, 31-May-04, to lugnet.cad.dat.parts)
|
