Subject:
|
Re: ldao 2.0.1 runtime error
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 22 Jan 1999 21:51:11 GMT
|
Viewed:
|
984 times
|
| |
|
|
Actually the problem is a lot more serious than that since this happen when I
try to start the modeler, editor or minifig modeler, I get the message box
followed by a crash right after clicking on the modeler button or menue
selection (same for the other tools mentioned)
Steve Bliss writes:
> Were you using the Swap command (pressing W in the Modeler)? There's a
> bug in that which will cause a type mismatch error.
>
> Unfortunately, there are enough serious bugs in 2.0.1 that I will need
> to publish a version 2.0.2 very soon. :( It's my own fault --
> inadequate testing.
>
> Steve
>
> On Fri, 22 Jan 1999 16:39:04 GMT, "Benoit" <Benoit.cerrina@writeme.com>
> wrote:
>
> > Hi,
> > I keep getting a runtime error '13' (type mismatch) whenever I use the
> > modeler, minifig modeler or editor in ldao 2.0.1. Can anybody help me.
> > PS:
> > the previous version of ldao (1.4.5 I think) worked fine
|
|
Message is in Reply To:
 | | Re: ldao 2.0.1 runtime error
|
| Were you using the Swap command (pressing W in the Modeler)? There's a bug in that which will cause a type mismatch error. Unfortunately, there are enough serious bugs in 2.0.1 that I will need to publish a version 2.0.2 very soon. :( It's my own (...) (26 years ago, 22-Jan-99, to lugnet.cad)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
