Subject:
|
Re: ldao 2.0.1 runtime error
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Fri, 22 Jan 1999 18:10:15 GMT
|
Viewed:
|
804 times
|
| |
|
|
Were you using the Swap command (pressing W in the Modeler)? There's a
bug in that which will cause a type mismatch error.
Unfortunately, there are enough serious bugs in 2.0.1 that I will need
to publish a version 2.0.2 very soon. :( It's my own fault --
inadequate testing.
Steve
On Fri, 22 Jan 1999 16:39:04 GMT, "Benoit" <Benoit.cerrina@writeme.com>
wrote:
> Hi,
> I keep getting a runtime error '13' (type mismatch) whenever I use the
> modeler, minifig modeler or editor in ldao 2.0.1. Can anybody help me.
> PS:
> the previous version of ldao (1.4.5 I think) worked fine
|
|
Message has 2 Replies:
 | | Re: ldao 2.0.1 runtime error
|
| Actually the problem is a lot more serious than that since this happen when I try to start the modeler, editor or minifig modeler, I get the message box followed by a crash right after clicking on the modeler button or menue selection (same for the (...) (26 years ago, 22-Jan-99, to lugnet.cad)
| | | Re: ldao 2.0.1 runtime error
|
| I'm sure it's hard to test without the benefit of many user's configurations and the different ways people use the program (which is a testament to its usefulness). What I have been doing is keeping two separate versions of LDAO installed: the (...) (26 years ago, 23-Jan-99, to lugnet.cad)
|
Message is in Reply To:
| | ldao 2.0.1 runtime error
|
| Hi, I keep getting a runtime error '13' (type mismatch) whenever I use the modeler, minifig modeler or editor in ldao 2.0.1. Can anybody help me. PS: the previous version of ldao (1.4.5 I think) worked fine (26 years ago, 22-Jan-99, to lugnet.cad)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
