Subject:
|
Re: LDAO problem--VEC check goes crazy
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 5 Jun 2000 17:46:32 GMT
|
Viewed:
|
635 times
|
| |
|
|
In lugnet.cad, Brian Durney wrote:
> Apparently the MS-DOS window titled PARTPROF has something to do with the
> problem. It shows up minimized and when I try to look at it, it goes away.
> Just now I realized that when I look at that PARTPROF window with the program
> stuck in the Checking VEC mode, the program stops and seems to be OK.
Make sure there's a PARTPROF.PIF file in your LDAO directory. In Explorer,
this file will probably show up just PARTPROF, with the type "Shortcut to
MS-DOS Program". If you've got the latest version of LDAO, this file
should be there. Right-click the file (in Explorer) and select Properties.
Click the Program tab, and make sure the "Close on Exit" option is checked.
Click OK, and your problem *should* be solved.
Steve
|
|
Message has 1 Reply:
 | | Re: LDAO problem--VEC check goes crazy
|
| I checked the properties and it did have "Close on Exit" checked. When I choose About from the Help menu, it says that I have version 2.1.3. Just out of curiosity I tried a few things like running PARTPROF from a DOS command line and executing the (...) (24 years ago, 5-Jun-00, to lugnet.cad)
|
Message is in Reply To:
| | LDAO problem--VEC check goes crazy
|
| Hello, I've been trying to set up LDAO and fixed the COMDLG32.OCX problem only to run into a new problem. When LDAO starts up it shows a progress bar with the words "Checking VEC XX%" where XX% is something like 20%. However, instead of stopping at (...) (24 years ago, 2-Jun-00, to lugnet.cad)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
