Subject:
|
Re: help with l-draw
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 15 May 2000 20:56:23 GMT
|
Viewed:
|
549 times
|
| |
|
|
In lugnet.cad, Tom Duggan writes:
> I have finally gotten around to trying to use l-draw, but I seem to have a
> problem....everytime I go to look at a piece using ldlite, it says "warning
> cannot find stud dat anywhere", and the pieces show with no studs. I have
> tried downlloading and installing everything twice, but i still get this
> message. does anyone know what I might be doing wrong? Or does any one know
> where I can find this part?
To check if you acualy have downloaded the stud parts, you must check your
\Ldraw\P folder. Besides other files, currently it should contain the
following (19) stud primitive files:
STU2.DAT
STU22.DAT
STU22A.DAT
STU23.DAT
STU23A.DAT
STU24.DAT
STU24A.DAT
STUD.DAT
STUD2.DAT
STUD2A.DAT
STUD3.DAT
STUD3A.DAT
STUD4.DAT
STUD4A.DAT
STUDLINE.DAT
STU2P01.DAT
STUDP01.DAT
STUDEL.DAT
STUD5.DAT
Greetings, M. Moolhuysen.
|
|
Message has 1 Reply:
 | | Re: help with l-draw
|
| (...) O.K.....I looked in my parts folder, and did not find them.....does anybody know where I can get them? I tried downloading ldraw, and the complete parts files again, and they are still not there. Thanks Tom D (25 years ago, 15-May-00, to lugnet.cad)
|
Message is in Reply To:
| | help with l-draw
|
| Hi, I have finally gotten around to trying to use l-draw, but I seem to have a problem....everytime I go to look at a piece using ldlite, it says "warning cannot find stud dat anywhere", and the pieces show with no studs. I have tried downlloading (...) (25 years ago, 15-May-00, to lugnet.cad)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
