To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / 3058
    Re: My first DAT file! —Mike Poindexter
   (...) I saw a double step in one part where only one was needed. Also, when you add the yellow round 1x1 plates to the back side, you should use a rotation step where you spin the model around 180 degrees. Although it doesn't show when you go (...) (25 years ago, 31-Oct-99, to lugnet.cad)
   
        Re: My first DAT file! —Larry Pieniazek
   (...) I caught that after I posted it, I was working by inserting a lot of steps in front of the trucks (which actually were the first things placed in the model, but then I built everything in front of them. I notice some people put the trucks (...) (25 years ago, 31-Oct-99, to lugnet.cad)
   
        Re: My first DAT file! —Mike Poindexter
   (...) think (...) whether (...) Any reason you use an axle pin instead of a normal pin? There are some instruction features that need to be added, like a submodel having a x33 for your hydrogen tubes and a part with an arrow pointing to where it (...) (25 years ago, 31-Oct-99, to lugnet.cad)
   
        Re: My first DAT file! —Larry Pieniazek
   (...) The reason is *either* - the normal pin doesn't seat well inside the 1x1 round because it is slightly longer/shorter/too wide/too narrow (choose one) OR - I had a lot of those other pins when I built it and not very many of the normal kind but (...) (25 years ago, 31-Oct-99, to lugnet.cad)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR