|
|
 | | Re: LPub Q's
|
| (...) ... snipped ... (...) I've moved the PLI around thinking it was underneath it but it didn't seem to make a difference. I will send you the MPD file so you can take a look at it. (...) I tried it but even though I told it to apply to only this (...) (14 years ago, 17-Sep-10, to lugnet.cad, FTX)
| | | | | Re: LPub Q's
|
| In lugnet.cad, Mike Walsh wrote: ... snipped ... (...) Things seem fine through page 14, and then they go away. One of two things come to mind. Either it is an LPub bug, or, possibly the page number is hiding the PLI? I'd make sure that the PLI is (...) (14 years ago, 17-Sep-10, to lugnet.cad, FTX)
| | | | | Re: LPub Q's
|
| (...) It doesn't help much, but it appears only on pages with a submodel used twice (x2). Perhaps it would help to see the mpd source file? (...) Right click on the model in the step where you want to reduce scale, choose "Change scale" and choose (...) (14 years ago, 17-Sep-10, to lugnet.cad)
| | | | | Re: LPub Q's
|
| In lugnet.cad, Kevin L. Clague wrote: ... snipped ... (...) I still come up for air every once in a while! ... .snipped ... (...) ... snipped ... I've resolved almost all of the issues I had run into but still have two I am struggling with, (...) (14 years ago, 17-Sep-10, to lugnet.cad, FTX)
| | | | | Re: Code Pilot LDraw
|
| (...) Depends on the model. Some models I can "see ahead" enough to change the order to make it easier to build virtually. But with a model this big, I mostly follow along with the instructions. The file does NOT have instruction steps though (...) (14 years ago, 15-Sep-10, to lugnet.cad)
|
|
