Subject:
|
Re: Tread part and use in MLCAD
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 30 May 2007 17:44:59 GMT
|
Viewed:
|
5982 times
|
| |
|
|
Don Heyse schrieb:
> In lugnet.cad, Kevin L. Clague wrote:
> > > In lugnet.cad, Ken Koleda wrote:
> > > > I have the need to use this tread part:
> > > >
> > > > http://www.peeron.com/inv/parts/43903 (used to be x203)
> > > >
> > > > I recall it took a while to find it (I think because there was only a
> > > > preliminary or unofficial(?) version).
> > > >
> > > > Anyhow, ideally I would be able to bend this part just slightly.
> > > > Several of my mocs use this part with four or five wheels and the
> > > > center 2 or 3 wheels are dropped one plate. IMO this makes the moc
> > > > look a little better and also makes it roll better as well. IIRC
> > > > the standard part will just run through the wheels.
>
> > LSynth supports rubber tread. If you have troubles chime in here.
>
> Actually I just recently started some work on the lsynth tread code
> and I think it only supports the larger rubber tread right now.
>
> I found the wheels for the small rubber treads on parts tracker, but I
> can't seem to locate the tread part(s). Could someone point me in the
> right direction?
>
> Don
Maybe you are looking for this
http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/x504.dat
cu
mikeheide
|
|
Message is in Reply To:
 | | Re: Tread part and use in MLCAD
|
| (...) Actually I just recently started some work on the lsynth tread code and I think it only supports the larger rubber tread right now. I found the wheels for the small rubber treads on parts tracker, but I can't seem to locate the tread part(s). (...) (19 years ago, 30-May-07, to lugnet.cad)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
