Subject:
|
Re: Tread part and use in MLCAD
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 23 May 2007 18:39:36 GMT
|
Viewed:
|
1870 times
|
| |
|
|
In lugnet.cad, Ken Koleda wrote:
> Hello,
>
> I have visited this topic a few times without much progress, but perhaps I am
> simply missing some key information.
>
> I have the need to use this tread part:
>
> http://www.peeron.com/inv/parts/43903
> (used to be x203)
>
> I recall it took a while to find it (I think because there was only a
> preliminary or unofficial(?) version).
>
> Anyhow, ideally I would be able to bend this part just slightly.
> Several of my mocs use this part with four or five wheels and the center 2 or 3
> wheels are dropped one plate. IMO this makes the moc look a little better and
> also makes it roll better as well. IIRC the standard part will just run through
> the wheels.
>
> It's been a real long time, but I do recall looking into creating my own part to
> achieve the desired effect.
>
> I am interested in hearing of anyone dealing with this, and what solutions have
> worked out (or not so much).
Have you tried LSynth? If I recall, it supports this part. Maybe kevin can
chime in help you out.
-Orion
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Tread part and use in MLCAD
|
| Hello, I have visited this topic a few times without much progress, but perhaps I am simply missing some key information. I have the need to use this tread part: (URL) to be x203) I recall it took a while to find it (I think because there was only a (...) (18 years ago, 23-May-07, to lugnet.cad)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
