Subject:
|
Re: New to MLCad - some questions
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 11 Oct 2004 07:40:02 GMT
|
Viewed:
|
954 times
|
| |
|
|
One more thing:
in the views, can I zoom in and just see the part where I am working?
Sure can, just how?
|
|
Message has 1 Reply:
 | | RE: New to MLCad - some questions
|
| click the part (in any view but the 3d view), press F5, drag the mouse up and down to change the zoom (or right click and select the zoom factor) then press F3 to revert to edit mode. -----Original Message----- From: news-gateway@lugnet.com (...) (20 years ago, 11-Oct-04, to lugnet.cad)
|
Message is in Reply To:
| | Re: New to MLCad - some questions
|
| (...) This takes a lot of getting used to. The problem is that when you rotate the plate 90 degrees, the arrow keys continue to work as though it was stud up - left moves it 1/2 stud left, up moves 1/2 stud back etc, instead of 1 plate or whatever (...) (20 years ago, 11-Oct-04, to lugnet.cad)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
