Subject:
|
Re: Modelling Pnuematics
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Wed, 31 Dec 2003 19:31:44 GMT
|
Viewed:
|
1008 times
|
| |
|
|
In lugnet.cad, Kevin L. Clague wrote:
> In lugnet.cad, Steven Lane wrote:
> > Trying to add pnuematics to one of my virtual creations has led me to come up
> > with a few suggestions to improve the current situation.
> >
> > Firstly we need a correctly sized tube. The flex tube is the same diameter as
> > the pnumatic nozzle so that's no good, it should fit over the nozzle.
> >
> > The new style of Pnuematic cylinder hasn't been created yet and I noticed when
> > you push the tube over the nozzle it creates a bulge. It would be great if the
> > pnumatic tube start piece was modelled to look like the short bulged section. A
> > non-bulged version for joining intermediate sections would also be needed.
>
> JP Brown has made one of these.
Great! I'll go and get it.
> I've started on the new style pneumatic switch. I've got the case and the lever
> worked out. Just need to get onto parts tracker.
>
> Have you tried LSynth for your hoses? It can easily do straight hoses.
I've had a lot of success since my earlier post, I cut down the long tube part
with bulged ends in LDDP and just used multiples of that.
Thanks
Steven
|
|
Message is in Reply To:
 | | Re: Modelling Pnuematics
|
| (...) JP Brown has made one of these. I've started on the new style pneumatic switch. I've got the case and the lever worked out. Just need to get onto parts tracker. Have you tried LSynth for your hoses? It can easily do straight hoses. Kevin (...) (21 years ago, 31-Dec-03, to lugnet.cad)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
