To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / *47227 (-5)
  Re: Beveled flex tubing  [DAT]
 
(...) That did it! Here's the part I needed... thanks again!!!! 0 ~Technic Flex-System Hose 45 bevel End 0 Name: 76_bevel3.dat 0 Author: Lar with hints from Philo 0 ROTATION CENTER 0 0 0 1 "Custom" 0 ROTATION CONFIG 0 0 0 WRITE Inner cylinder (...) (14 years ago, 24-May-11, to lugnet.cad)
 
  Re: Beveled flex tubing
 
(...) Google translate does a pretty fair job, actually, enough to suss out most of what is being said... Manfred's section of notes in the part authoring "tutorial" (URL) is also helpful (URL) wasn't aware that there was a sliced cylinder primitive (...) (14 years ago, 24-May-11, to lugnet.cad)
 
  Re: My attempts to get a vector line drawing
 
(...) Hey, this is interesting. Is it actually just drawing the visible lines in some final rendering stage? Or is there more going on there with the Stencil and/or Depth buffer? (14 years ago, 24-May-11, to lugnet.cad, FTX)
 
  Re: Beveled flex tubing
 
OK, I think what you miss is the 4-4cyls.dat primitive, add it to a regular 4-4cyli and you basically have what you need. For the tip, you need a slanted primitive (ring and edges). There is a tutorial (unfortunately in French) here (URL) , (...) (14 years ago, 24-May-11, to lugnet.cad)
 
  Re: Beveled flex tubing
 
(...) I was looking at trying to use your cutting tool, actually,.. stretch a 4-4cyli.dat to a long enough length (somehow?) and then just use a big quad tilted to 45 degrees as the "blade". But I can't quite suss out how to do it, being somewhat (...) (14 years ago, 24-May-11, to lugnet.cad)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR