 | | LD4DStudio suggestions?
|
|
Hello all, I was wondering if people have some minor suggestions / bug reports for my current LD4DStudio version. Work on the 1.1 version is taking longer than expected so I was planning to release a bugfix only version this month. Any additional (...) (16 years ago, 12-Dec-08, to lugnet.cad)
|
| |
| | Re: Conditional Ring primitive?
|
|
(...) My comment about needing twice the geometry for the edge was based on a misunderstanding of what you wrote. Based on what I now assume you meant, two wouldn't be required for each joint. However, your solution would only work if the cones on (...) (16 years ago, 12-Dec-08, to lugnet.cad)
|
| |
| | Re: Conditional Ring primitive?
|
|
(...) It sounds like it would work, but I'm not sure if people would go for it. Of course, if the POTM competitions are anything to go by, you're making a majority of the complicated parts right now, so if you go with it, that's probably all we need (...) (16 years ago, 12-Dec-08, to lugnet.cad)
|
| |
| | Re: Conditional Ring primitive?
|
|
(...) Mmhhh... maybe by setting 2 conditional rings on the junction. Each condring would be set between a cylinder and a cone. Scaling the ring would adapt to various cone slopes. Of course 2 rings would be needed, one for converging cones, one for (...) (16 years ago, 12-Dec-08, to lugnet.cad)
|
| |
| | Re: Conditional Ring primitive?
|
|
(...) That's a primitive I have been longing for... but I realized it is impossible to build: where would you put the control lines? The top control points would need to be scaled differently from bottom ones to match various cylinders/cones (...) (16 years ago, 12-Dec-08, to lugnet.cad)
|
