 | | Re: Lego factory sets / building instructions
|
|
Paul S. D'Urbano wrote: [...] (...) [...] (...) Paul, It would be great if the models were built and commented on. I know the few models that I submitted are buildable, but that kid of defeats the real purpose of Factory... I mean really, if I (...) (19 years ago, 29-Nov-06, to lugnet.trains, lugnet.cad.ldd)
|
| |
| | Has anyone made the x93 Monkey Wrench
|
|
(URL) need it to finish the AT-AT. (19 years ago, 29-Nov-06, to lugnet.cad)
|
| |
| | Re: LSynth electric cable cross section oriention problem
|
|
(...) Me too! Kevin (19 years ago, 27-Nov-06, to lugnet.cad.dev)
|
| |
| | Re: Tyre 30.4x14
|
|
ludo soete schrieb: (...) On Peeron this part has the number: 30391. But it is not on the parts tracker. mikeheide (19 years ago, 26-Nov-06, to lugnet.cad.dat.parts)
|
| |
| | Re: LSynth electric cable cross section oriention problem
|
|
(...) Hi Kevin, Another possibility to investigate is to change the up vector in inverse proportion to the bezier curve change. That would mean it would twist less where there's a sharper bend, and would possibly end up looking more authentic. But (...) (19 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | Re: LSynth electric cable cross section oriention problem
|
|
(...) Leo, In case you didn't get this far, I solved the above problem and can now control twist all through a cable segment from start point to end point. I calculate the up vector for the start of segment, and the up vector for the end of segment. (...) (19 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | LDAO problem
|
|
i guess this would be the correct spot for the message. i have a install problem with LDAO. i install it, and when i stat it i get error 76 , path not found. (19 years ago, 26-Nov-06, to lugnet.cad.dev)
|
| |
| | Tyre 30.4x14 VR
|
|
Hi all, Anyone having a mocup from the following tyre? (...) Any help with a mocup is apreciated. Regards, Ludo (19 years ago, 25-Nov-06, to lugnet.cad.dat.parts, FTX)
|
| |
| | Tyre 30.4x14
|
|
Hi all, Anyone having a mocup from the following tyre? (URL) I noticed the request for it abouth 4 years ago, and it is still not apearing on the LDRAW site - unofficial parts. Any help with a mocup is apreciated. Regards, Ludo (19 years ago, 25-Nov-06, to lugnet.cad.dat.parts, FTX)
|
| |
| | Re: DAT file for 4531-9V Switches
|
|
(...) on LDraw's parts tracker searching for 4531. Thanks in advance for any (...) tracking it down. Hi, Take here a look for a mocup of the 9V RC points (100% plastic) by Thomas Burger: (URL) They are build after my mocup for the 9V point (with (...) (19 years ago, 25-Nov-06, to lugnet.cad.dat.parts, FTX)
|
