 | | Re: LPub problems
|
|
(...) I don't think this is the best way either. The best fix is to just get rid of the C:\ and go with a good relative path. I tested this a while back and found that entering "../Images" in the lpub URL box works on both IE and Mozilla. My image (...) (19 years ago, 15-Jun-05, to lugnet.cad)
|
| |
| | Re: Callout a single part
|
|
(...) It just creates an alternate solution for something that I have already provided. (...) I'm wondering if this will work in your higher level model: 0 BUFFEXCHG A STORE 0 LPUB CALLOUT BEGIN 1 0 0 0 0 1 0 0 0 1 0 0 0 1 sub8callout.ldr 0 LPUB (...) (19 years ago, 15-Jun-05, to lugnet.cad)
|
| |
| | Re: Callout a single part
|
|
(...) Sorry, I meant: By placing LPUB SUBMODEL_STEP BEGIN IGN prior to the 0 STEP command in a submodel, the following steps will be ignored until the next LPUB SUBMODEL_STEP END meta command and not show in the callout. (19 years ago, 15-Jun-05, to lugnet.cad)
|
| |
| | Re: Callout a single part [DAT]
|
|
(...) I agree that it does, but I think it is a bit too circuitous. I suppose this is too difficult to implement in LPub For now then making a submodel for each callout with only one part and no step in it, doing it like this makes me (once again) (...) (19 years ago, 15-Jun-05, to lugnet.cad)
|
| |
| | Re: LPub and margins, margins, margins......
|
|
(...) Hello Kevin, I would prefer having all dimensions relative to page size. This way you can render fast, small rendering for debug and webpages, and with the same "source code" create high-res renderings for printing (ideally even CSI/PLI images (...) (19 years ago, 15-Jun-05, to lugnet.cad)
|
