| | Slope parts with patterns...
|
|
Would making the pattern face of a slope (or wedge) a subpart to be used with the main piece (without face) subpart be ok? I'm thinking, that for slopes (and wedges), it would be easier to make the pattern a flat subpart, then rotate the subpart to (...) (20 years ago, 22-Feb-05, to lugnet.cad.dat.parts)
|
|
| | Re: LDraw.org Contributer Agreement Status
|
|
(...) On this point, the ONLY way for me to reach the widest amount of people possible is for people who read this message to spread to word. I made a conscious (and correct) decision not to massively cross post this thread to increase exposure. I (...) (20 years ago, 21-Feb-05, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: LDraw.org Contributer Agreement Status
|
|
(...) You are! Sproat agreed very promptly once Orion was able to reach him. (20 years ago, 21-Feb-05, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: LDraw.org Contributer Agreement Status
|
|
(...) Hi Jeremy! Yours was one of the names that I figured just wasn't getting through due to something silly like this. I also figured that you'd come through and approve the new agreement so that the parts you created could continue to be (...) (20 years ago, 19-Feb-05, to lugnet.cad.dev.org.ldraw)
|
|
| | Re: Status of BFC
|
|
(...) It looks like 1058 files are BFC-compliant, out of 2945 official part files. (...) It doesn't look like you'll be able to make that assumption. Steve (20 years ago, 21-Feb-05, to lugnet.cad.dev)
|