 | | Re: Problem to synthesize Rubber Tread
|
|
(...) I wrote a little tutorial about mlcad and lsynth: (URL) may helps. w. (20 years ago, 2-Nov-04, to lugnet.cad)
|
| |
| | Re: Problem to synthesize Rubber Tread
|
|
(...) Heh, that'll teach ya to allow ordinary parts as constraints. You need really some cool constraints with colored bullseyes, and arrows, and transparent sides, and all that stuff... Enjoy, Don (20 years ago, 2-Nov-04, to lugnet.cad)
|
| |
| | Re: Problem to synthesize Rubber Tread
|
|
(...) Gustavo, The two constraints don't affect each other, so two groups of four tries is sufficient. The other thing to try is flip the constraint around, so that the other face of the wheel faces you. You might have to rotate 90, 180, 270 from (...) (20 years ago, 2-Nov-04, to lugnet.cad)
|
| |
| | Re: Problem to synthesize Rubber Tread
|
|
Thank you Kevin I tried all combinations, 0,90,180,270 degrees for both constraints, in total sixteen alternative, and it didn't work (URL) suggestion. Best Regards Gustavo (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Beta testers?
|
|
(...) Vineet, As Chris pointed out...... I answered this before......the very first time you asked the question. Put your cursor in the POV-Ray control window. Use the File->Close All menu item. It should close all the open pov files. Did you try to (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Renderer Questions
|
|
(...) (URL) Two burgers anda shake please! :) (20 years ago, 1-Nov-04, to lugnet.cad, FTX)
|
| |
| | Re: Beta testers?
|
|
Kevin- When I'm rendering my design, the window that allows you to run the rendering comes up. Mine is clogged with other rendering designs (des.1, des.2, etc). Do you know how to clear it up? (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Beta testers?
|
|
Hi, I've been doing a lot of work on LPub over the last few months (its about time!), and I was looking for Beta testers. So far Mike and Rosco have voluneteered. The changed to LPub are all related to building instruction image generation. Some (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Howto on : BFC "Hold" on 47457.dat
|
|
(...) Lots of thanks for the reviews! I'll make the amends later this week and resubmit. Forward and onward! :-) Edwin (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: Howto on : BFC "Hold" on 47457.dat
|
|
(...) This has nothing (well, almost nothing) to do with BFC, but your tube on the underside of the part should use stud4a, up to the point where the tube meets main part. (...) Chris Dee explained the basic process tracking down non-compliant (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
