 | | Re: Howto on : BFC "Hold" on 47457.dat
|
|
Given that the part isn't BFC-certified (no BFC comments in the file at all), it by definition cannot contain any BFC errors. For reasons I don't understand, L3Lab is displaying it as if it were BFC-certified. I would suggest pointing out to Steffan (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Howto on : BFC "Hold" on 47457.dat
|
|
I got an e-mail notice that a review of 47457.dat revealed BFC errors. I really don't know how to check for BFC compliance. All I did was to turn the part around to see if any of it was red. I know there's a caveat that some lines bleed red. I (...) (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Problem to synthesize Rubber Tread
|
|
Hi, I have problem to draw a Rubber Tread with MLCad and LSynth, when the process finishes it shows an intermitent Rubber Tread. Please any help will be apreciated (URL) moderation) Gustavo Brinck Lugnet Member 566 Santiago Chile (20 years ago, 1-Nov-04, to lugnet.cad)
|
| |
| | Re: 3 x 2 Wedge Plates
|
|
(...) Please understand that I wasn't harping on it to you guys. I had my bit of that, then Steve explained the situation to me (that it's a known problem, that it's being discussed, and that all Wedge Plates will probably end up as Wings), and now (...) (20 years ago, 31-Oct-04, to lugnet.cad)
|
| |
| | Re: 3 x 2 Wedge Plates
|
|
(...) Gah! Um, they have been made for LDraw, but those parts have not yet been approved. You can download the requisite files from here: (URL) Right> (URL) Left> Make sure you grab the subfiles and put them all in the right directories or the parts (...) (20 years ago, 31-Oct-04, to lugnet.cad, FTX)
|
