|
| | Re: Naming of parts
|
| (...) Then you'd just use "Plate 4 x 8 Without Corner Left" and "Plate 4 x 8 Without Corner Right" -Orion (21 years ago, 4-Feb-04, to lugnet.cad.dat.parts)
| | | | Re: Naming of parts
|
| (...) If LEGO were to produce a rectangular plate, say a 4x8, with a missing corner, what would be a good way to describe it? The part could easily have a mirror-image part, so it wouldn't be enough to say "Plate 4 x 8 without corner," since that (...) (21 years ago, 4-Feb-04, to lugnet.cad.dat.parts)
| | | | LDraw.org Bylaws - new proposed clauses
|
| Thanks to everyone who has been participating in the bylaws discussion. These are important issues, and in my view the opinions put forth have been by and large well thought out and productive. I think we've covered the lion's share of the possible (...) (21 years ago, 4-Feb-04, to lugnet.cad.dev.org.ldraw, FTX)
| | | | Re: Naming of parts
|
| (...) This one should be Wing 3 x 4 (...) These ones are plates with one corner clipped, I think the 'Without Corner' label is better than Wing. I'd like to add these ones to the list: 2621 2625 I had renamed 2625 while it was on the PT for BFC (...) (21 years ago, 4-Feb-04, to lugnet.cad.dat.parts)
| | | | Re: Naming of parts
|
| (...) How about these two: 30033 Plate 2 x 2 with Rod Frame Octagonal (URL) 30094 Bar 4 x 4 with 4 Studs (No entry at LUGNet) I suggest changing the last to: 30094 Plate 2 x 2 with Rod Frame Rectangular Christian (21 years ago, 4-Feb-04, to lugnet.cad.dat.parts, FTX)
| |