 | | Ldraw/MLCAD question
|
|
I've got a MLCAD/LDraw question. Ive just loaded it onto my computer, although I'm not sure I downloaded/expanded every component to just where it should be (like in the same folder, etc), although i've tried to move everything back now. When I open (...) (21 years ago, 14-May-03, to lugnet.cad)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT)
|
|
(...) I think the O could be done with overlapping rings (and roughly 3/4 of the C), now that I think about it (I may try it before converting everything over to quads). But considering the C cannot be done without using quads, it may look odd that (...) (21 years ago, 14-May-03, to lugnet.cad.dat.parts)
|
| |
| | Re: door 1 x 3 x 1 new patterns and errors in parts on PT
|
|
Steve, I sent you an email regarding my inability to access the PT (either my password has been reset or my authoring privleges have been reset). I can't make any corrections to my parts until then. But the files are ready to submit. I corrected (...) (21 years ago, 14-May-03, to lugnet.cad)
|
| |
| | Re: Ver 0.73.1 & Minifig Wizard
|
|
Hello there, I have exactly the same problem: since the installation of the new version the minifig wizard gives an 'this program has performed an illegal operation' error (21 years ago, 12-May-03, to lugnet.cad.leocad)
|
| |
| | Re: POLICE Pattern (was Re: door 1 x 3 x 1 new patterns and errors in parts on PT)
|
|
(...) Me, too. But there aint no rings with a x-radius-difference of 1 and z-radius-difference of 1.125. Or you need to have overlapping rings. Even using ndis, segm (chord) primitives and triangles filling up is not possible, because the outer (...) (21 years ago, 14-May-03, to lugnet.cad.dat.parts)
|
