 | | To boldly MLCAD where no one has MLCADed before
|
|
I thought my computer was powerful until this. 131369 Frame level objects I put my computer down to its knees Prepare to drool (URL) (24 years ago, 26-Nov-00, to lugnet.cad.dat.models)
|
| |
| | Re: bend thingie creator.
|
|
(...) I've thought about using bezier curves but I decided to choose another type of curve because it doesn't allow you to make the curve pass by a specific point (except the first and last points). (...) I'm using a different solution: I start with (...) (24 years ago, 26-Nov-00, to lugnet.cad.dev)
|
| |
| | Re: Export Problems
|
|
(...) I don't use the export function so I can't comment. But if you want to raytrace, get POVray, install it, then get L3Lab (or L3P) and install it. What I do to trace is save my MPD with the design I want traced. Then I launch L3Lab, navigate to (...) (24 years ago, 26-Nov-00, to lugnet.cad.mlcad)
|
| |
| | Re: Renderers that poll for changes?
|
|
(...) With 420 Mb hard disk and 16 Mb RAM, it's no upgrade at all. (RAM not even upgradeable). I prefer a fast 486 with Win 3.1 before a slow one with Win95. I have no hope of finding a polling viewer that works in Win 3.1. I want to know what (...) (24 years ago, 27-Nov-00, to lugnet.cad)
|
| |
| | Export Problems
|
|
I'm fairly new to MLCad, and after I recently got ready to delve into the depths of raytracing my designs, I found that the export command was a little odd... I can't click the post processor configurations tab; it doesn't act as if it's a tab at (...) (24 years ago, 26-Nov-00, to lugnet.cad.mlcad)
|
