 | | Re: What CAD program is being auctioned here ?
|
|
(...) Geez, that sounds like MLCad to me. If it is, someone is gonna get taken to the cleaners for free software. Yeesh. Ben (25 years ago, 10-Feb-00, to lugnet.cad)
|
| |
| | What CAD program is being auctioned here ?
|
|
Anyone know anything about this? (URL) (25 years ago, 10-Feb-00, to lugnet.cad)
|
| |
| | Line of error
|
|
I have just finished looking through some posted dat-files. And of course they had errors. Mainly because of linewrap. MLcad announces politely that there is an error. But why not tell the linenumber too?!. That would make errorfinding a lot easier. (...) (25 years ago, 10-Feb-00, to lugnet.cad.mlcad)
|
| |
| | Re: Looking for a part
|
|
(...) I wrote 9 degrees from memory. I couldn't locate the previous discussion. (...) least three Spaceport sets, and the Mos Espa Podrace set. (...) Hmm. I wonder what caused the variation. A few ideas: 1. Differences between the molds in the (...) (25 years ago, 10-Feb-00, to lugnet.cad.dev)
|
| |
| | Re: 8448 Flexible Axles (was Re: Parts from 8448 not LDrawn)
|
|
(...) Found it! (URL) They were *not* introduced in Znap. But the odd length axle with the stop-collar *was* introduced in Znap. (URL) So, should these parts be included in Technic, or should a new category for Znap be started? Steve (25 years ago, 10-Feb-00, to lugnet.cad.dev)
|
| |
| | Re: 8448 Flexible Axles (was Re: Parts from 8448 not LDrawn)
|
|
(...) Ah! Thank you, Wayne. (...) From the rumblings in lugnet.loc.uk, it doesn't seem likely -- people only appreciate Znap when it's on clearance. :-/ Steve (25 years ago, 10-Feb-00, to lugnet.znap, lugnet.cad.dev, lugnet.dear-lego)
|
| |
| | Re: 8448 Flexible Axles (was Re: Parts from 8448 not LDrawn)
|
|
(...) The first use is on page 153 (book 2). They're used to make the curves in the body-lines. Steve (25 years ago, 10-Feb-00, to lugnet.cad.dev)
|
| |
| | Re: 8448 Flexible Axles (was Re: Parts from 8448 not LDrawn)
|
|
(...) Were *what*? Steve (25 years ago, 10-Feb-00, to lugnet.cad.dev)
|
| |
| | Re: stl2dat conversion tool beta2
|
|
(...) STL only support triangles. Nurbs (and other geometry) must be converted by the CAD software to triangles. That's why I choosed STL : it already contains triangles and that's very near LDraw format. (In a geometric point of view) (...) Yes, I (...) (25 years ago, 10-Feb-00, to lugnet.cad.dev)
|
| |
| | Re: POV or L3P help
|
|
(...) Ok, now we're talking! Thanks. -Patrick S-L (25 years ago, 10-Feb-00, to lugnet.cad)
|
