Subject:
|
Re: New Use of 1x1 plate w/clip light?
|
Newsgroups:
|
lugnet.build
|
Date:
|
Sun, 12 Mar 2000 03:11:23 GMT
|
Viewed:
|
3773 times
|
| |
|
|
In lugnet.build, Karim Nassar writes:
> In lugnet.build, Richard W. Schamus writes:
> > In lugnet.build, Bryan Wong writes:
> > > In case you don't know what piece I'm talking about, it's the one shown • here:
> > > http://home.att.net/~partsref/images/4081.gif
> > >
> > > Anyways, when I was younger, I remember "breaking" off the round clip part • and
> > > use it to join two pieces "back to back" (or "socket to socket"). I'm sure
> > > that would come in useful in some situations.
> > >
> > > Anybody else try this before?
> > >
> > > Bryan
> > Oh yes, me and making things into 2 or more useful (most of the time) pieces
> > go wwwaaaaayyyy back.
>
> Me too. A lot of my models use this (and some others) in similar ways.. In
> the past, I used to snap them off, but recently, I've been more careful to
> try to use the whole piece... I've found with a little imagination, it's
> usually possible to achieve the desired effect without sacrificing a piece.
>
> Did you know that there are two versions of this piece? They are both very
> usefull in different ways... They differed in the thickness of the ridge
> between the two studs on the clip part... If you used them both to join two • 1x1
> plates back to back, the older style (thinner) would result in an assembly
> whose width is equal to the width of a 1x1 brick. The newer style (thicker)
> resulted in an assembly whose width is equal to the height of a 1x1 brick. • Very
> important distiction... The first type is used in:
>
> http://www.etymon.org/kn/pallas/Products/Guns.gif
>
> The second type is used in:
>
> http://www.etymon.org/kn/pallas/Products/ghost.html
>
> It's hard to see, but they are used to hold the saucer sections together at • the
> rear of the ship.
>
> --Karim
Yes I did know that, my collection is old enough to have noticed the change,
(I've collected and built from the early '70's on). I have both types, and
wish I had more of both.
Rich
--
Have Fun! C-Ya!
Legoman34
*****
Legoman34 (Richard W. Schamus)... (No, I don't work for TLC, but I want
to...)
Card carrying LUGNET MEMBER: #70
Visit http://www.wamalug.org &
http://www.geocities.com/TimesSquare/Castle/1334
...(the wait is over...)
..."The only thing we have to fear, is fear itself." ...
*****
|
|
Message is in Reply To:
 | | Re: New Use of 1x1 plate w/clip light?
|
| (...) and (...) Me too. A lot of my models use this (and some others) in similar ways.. In the past, I used to snap them off, but recently, I've been more careful to try to use the whole piece... I've found with a little imagination, it's usually (...) (27 years ago, 11-Mar-00, to lugnet.build)
|
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
