 | | Re: wishin' on a star
|
| (...) I think you meant 2x2x1, since those are the dimensions of the R2-D2 head (the taller version is still only 2x2x1-2/3). (...) If you can get parts out to photo-paint to turn into new pieces, just build the rest of the stuff in mlcad, bring it (...) (22 years ago, 7-Jul-04, to lugnet.build, FTX)
| | | | | Re: wishin' on a star
|
| (...) The stud notches pretty much peg it as a 2x2. (...) I was able to figure them all out without any trouble, with only a few exceptions: 1. Double-ended clip plate (not sure why the other two variants weren't included). 4. 1x1 round tile. 6. (...) (22 years ago, 7-Jul-04, to lugnet.build, FTX)
| | | | | Re: wishin' on a star
|
| (...) it's a 2x2x2. (...) unfortunately, i'm flying by the seat of my pants here. while i figured out how to go from mlcad drawing to jpg to photo-paint, i haven't figured out the reverse process. now that i've got a new piece, how do i get it back (...) (22 years ago, 7-Jul-04, to lugnet.build, FTX)
| | | | | Re: wishin' on a star
|
| (...) As I suspected. Your surgery worked! (...) Ah, OK. So is it only 1 stud around or is it a 2x2? The view you chose didn't make that clear. For a couple of these parts showing them in use with another part, or showing several angles, might (...) (22 years ago, 7-Jul-04, to lugnet.build, FTX)
| | | | | Re: wishin' on a star
|
| (...) thanks! i used mlcad to put one, two or more pieces together, took a jpg photo then went into photo-paint to doctor it up. (...) it's the smaller version of the bell jar but it has no centre stud, therefore when used upside down, has a lovely (...) (22 years ago, 7-Jul-04, to lugnet.build, FTX)
|
|
