Subject:
|
RE: bricks upside down
|
Newsgroups:
|
lugnet.build
|
Date:
|
Fri, 14 Sep 2001 18:39:20 GMT
|
Reply-To:
|
<bram@po+NoMoreSpam+.cwru.edu>
|
Viewed:
|
335 times
|
| |
|
|
Fredrik Glöckner writes:
> What is your favourite way to connect bricks upside down? Bricks
> upside down is commonly useful in buildings eg. for putting arches
> upside down. Do you simply use tiles and slot in the bricks without
> any connection?
I like stuff to be fixed, so just sliding in the parts isn't good enough for
me. :) Upside down stuff is easiest to do in a wall that's at least 2 studs
thick, in my experience. Here are some solutions that can be used in a 1
stud wide space (but with gaps).
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=69855
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=69856
In a two stud wide space, these brick combinations give a completely flush
surface on one side. They can of course be supplemented with bricks,
plates, and tiles.
--Bram
Bram Lambrecht
bram@cwru.edu
http://bldesign.org/
|
|
Message is in Reply To:
 | | bricks upside down
|
| What is your favourite way to connect bricks upside down? Bricks upside down is commonly useful in buildings eg. for putting arches upside down. Do you simply use tiles and slot in the bricks without any connection? One method I can see is using the (...) (23 years ago, 14-Sep-01, to lugnet.build)
|
8 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
