 | | Re: New Space Ship added to site, check it out!
|
|
(...) Microfig is a scale, not an actual figure, that is anything smaller than minifig scale. -Tom McD. (26 years ago, 14-Jan-99, to lugnet.build)
|
| |
| | Re: New Space Ship added to site, check it out!
|
|
(...) Grrr, Hate to show my ignorance nut what is a microfig? have I missed something or are these just hypothetical? Cheers Tim (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | Re: Do these elements exist in green? If you have some will you sell?
|
|
followups set to trains... (...) However, they are a bit more selectively compressed than I care for. :-) Mine has two motors, of course, instead of a stubby second truck. Also, I think the shoulder isn't quite right. I never do ascii art but here (...) (26 years ago, 13-Jan-99, to lugnet.market.buy-sell-trade, lugnet.trains, lugnet.build)
|
| |
| | Re: New Space Ship added to site, check it out!
|
|
(...) look-and-feel that really appeals to me. Their scale and shape kinda remind me of the spacecraft seen in the movie Independence Day. (...) I've been playing with the idea of a microfig-scale fleet for a while. My first Lego aircraft were this (...) (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | New Space Ship added to site, check it out!
|
|
Check it out! Tell me what you think! (URL) up is a Gravwell Micro-fig scale cruiser. Later, pat (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | Re: 60 degree problem
|
|
(...) trying (...) :-/ That's pretty much the same conclusion I came to. Unfortunately, I can't get enough stability from that with the current design. <sigh> Back to the drawing board <grumble grumble bitch bitch> I _liked_ that design too. Maybe (...) (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | Re: 60 degree problem
|
|
(...) A 3 blade rotor will give the same angle geometry but I don't beleive it is what James is asking. I believe he is asking how to anchor something to the top of this assembly that is connected to all three legs. Geometrically, there is no (...) (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | Re: 60 degree problem
|
|
(...) Whoops, this is not what I thought. Typing too fast. If this is 2 plates, one with 2 fingers and one with 3 fingers on the end, which coupled together take the same space as a 1x5 plate would, these are "two finger" and "three finger" hinges. (...) (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | Re: 60 degree problem
|
|
(...) connect (...) my (...) these (...) Have you tried a Technic 3 blade rotor? It's not *quite* what you are trying to build, but I think it should be workable. Duane (26 years ago, 13-Jan-99, to lugnet.build)
|
| |
| | Re: 60 degree problem
|
|
(...) normally (...) to (...) a (...) Ok, it's fairly obvious I wasn't clear enough (I can't even figure out what I meant <grin>) so here is a second attempt. The part I am using as the major component of my foot design is the (aucZILLA (...) (26 years ago, 13-Jan-99, to lugnet.build)
|
