 | | Re: Hafhead's Iron Mecha Progress
|
|
(...) Hi Tony, This is a good start and your upper torso is quite good overall but your legs are waaay to skinny. My major suggestion would be to fatten them up. After fattening the legs you might also want to make the waist a bit bigger but see how (...) (19 years ago, 11-Jan-06, to lugnet.build.mecha, FTX)
|
| |
| | Hafhead's Iron Mecha Progress
|
|
Here's my first attempt: Main shot: (URL) And I've got a (URL) rear view>. Iron Mecha reference image: (URL) Please be blunt with feedback- I don't have much experience building mecha and would welcome anything (whether I use it or not). (2 URLs) (...) (19 years ago, 11-Jan-06, to lugnet.build.mecha, FTX)
|
| |
| | Re: Worm gear driven turntable
|
|
(...) I'm not sure how he did the 4x4 plate either, unless he drilled it. I made this turntable and used a 2x2 round plate. Worked like a charm. -Brian (19 years ago, 11-Jan-06, to lugnet.build.mecha)
|
| |
| | Re: Worm gear driven turntable
|
|
(...) I think it's actually a 2x2 round plate in the center, with four 2x2 corner plates surrounding it. It's a bit hard to tell from the photo though. -Elroy (19 years ago, 11-Jan-06, to lugnet.build.mecha)
|
| |
| | Re: Worm gear driven turntable
|
|
(...) Great Job! But I had trouble with the top. There appear to be four 4 x 4 plates that fit over the small turntable and are wedged against the axle so as to form a surface that spins with the axle. When I try this, the plates do not fit. Are (...) (19 years ago, 11-Jan-06, to lugnet.build.mecha)
|
