Subject:
|
Re: Worm gear driven turntable
|
Newsgroups:
|
lugnet.build.mecha
|
Date:
|
Wed, 11 Jan 2006 17:37:50 GMT
|
Viewed:
|
9734 times
|
| |
|
|
In lugnet.build.mecha, Elroy Davis wrote:
> In lugnet.build.mecha, Mitchell Lichtenberg wrote:
> > In lugnet.build.mecha, Christopher Snead wrote:
> > > So I've been working on various wormgear combinations over the past week or so,
> > > and I came up with something that might be of use to folks:
> > >
> > > http://brickshelf.com/cgi-bin/gallery.cgi?i=1567084
> >
> > Great Job! But I had trouble with the top. There appear to be four 4 x 4
> > plates that fit over the small turntable and are wedged against the axle so as
> > to form a surface that spins with the axle. When I try this, the plates do not
> > fit. Are those special plates or have I missed something here. Thanks
>
> I think it's actually a 2x2 round plate in the center, with four 2x2 corner
> plates surrounding it. It's a bit hard to tell from the photo though.
>
> -Elroy
I'm not sure how he did the 4x4 plate either, unless he drilled it. I made this
turntable and used a 2x2 round plate. Worked like a charm.
-Brian
|
|
Message is in Reply To:
10 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
