Mecha : 13848


Building / Mecha / 13848	13847 \| 13849

Subject:	Re: Worm gear driven turntable
Newsgroups:	lugnet.build.mecha
Date:	Wed, 11 Jan 2006 16:14:32 GMT
Viewed:	1858 times

In lugnet.build.mecha, Christopher Snead wrote: > So I've been working on various wormgear combinations over the past week or so, > and I came up with something that might be of use to folks: > > http://brickshelf.com/cgi-bin/gallery.cgi?i=1567084 Great Job! But I had trouble with the top. There appear to be four 4 x 4 plates that fit over the small turntable and are wedged against the axle so as to form a surface that spins with the axle. When I try this, the plates do not fit. Are those special plates or have I missed something here. Thanks

Message has 2 Replies:

		Re: Worm gear driven turntable
(...) I think it's actually a 2x2 round plate in the center, with four 2x2 corner plates surrounding it. It's a bit hard to tell from the photo though. -Elroy (19 years ago, 11-Jan-06, to lugnet.build.mecha)

		Re: Worm gear driven turntable
(...) There is a 2x2 round plate in the center, surrounded by the 2x2 plates with a corner missing. Chris Thanks (19 years ago, 11-Jan-06, to lugnet.build.mecha)

Message is in Reply To:

		Worm gear driven turntable
So I've been working on various wormgear combinations over the past week or so, and I came up with something that might be of use to folks: (URL) like the technic geared turntables, but they are a bit big. So I thought it would be nice to have a (...) (19 years ago, 10-Jan-06, to lugnet.build.mecha) !

10 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search